IT Questions Bank Why is it important to record baseline measurements of a prototype network?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. What two measures can be taken to address the areas of weakness circled in the network design? (Choose two.)ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. The users on the 192.168.10.192 network are not allowed Internet access. The network design calls for an extended ACL to be developed and tested. Where should the ACL be placed for the least effect on other network traffic?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. In the router command encapsulation dot1q 10, what does the number 10 represent?ITExamAnswers asked 8 months ago • CCNA Discovery v4A network designer needs to determine if a proposed IP addressing scheme allows efficient route summarization and provides the appropriate amount of scalability to a design. What is useful for validating a proposed hierarchical IP addressing scheme?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. The redundant paths are of equal bandwidth and EIGRP is the routing protocol in use. Which statement describes the data flow from Server to PC2?ITExamAnswers asked 8 months ago • CCNA Discovery v4Switch port Fa0/24 was previously configured as a trunk, but now it is to be used to connect a host to the network. How should the network administrator reconfigure switch port Fa0/24?IT Administrator asked 3 years ago • CCNA Discovery v4, CCNA SecurityRefer to the exhibit. During prototype testing, verification of VLAN connectivity is being performed. Based on the information shown, what command produced the output?ITExamAnswers asked 8 months ago • CCNA Discovery v4What Rapid Spanning Tree Protocol (RSTP) state is given to the forwarding port elected for every switched Ethernet LAN segment?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. During prototyping, Layer 2 functionality is being tested. Based on the output shown, which two pieces of information can be determined? (Choose two.)ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. During prototype testing of the Cisco network shown, connectivity must be verified. Assuming all connections are working and CDP is enabled on all devices and interfaces, on which device was the command issued?ITExamAnswers asked 8 months ago • CCNA Discovery v4How do designers decide which network functions need to be included in the prototype test?ITExamAnswers asked 8 months ago • CCNA Discovery v4What OSI model Layer 2 security measure can a network engineer implement when prototyping network security?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. A network designer creates a test plan that includes the specification shown. In which section of the test plan would this specification be found?ITExamAnswers asked 8 months ago • CCNA Discovery v4While preparing a network test plan document, a network designer records all initial and modified device configurations. Which section of the document typically contains this information?ITExamAnswers asked 8 months ago • CCNA Discovery v4