IT Questions Bank You have created and IPv6 ACL called MY-LIST. Which command would you configure to use this ACL to check Inbound packets on an Interface?ITExamAnswers asked 1 year ago • CCNP ROUTEWhich rules are implicit at the end of every IPv6 ACL?ITExamAnswers asked 1 year ago • CCNP ROUTEWhich is a characteristic of dual-homed connectivity?ITExamAnswers asked 1 year ago • CCNP ROUTERefer to the exhibit. A network engineer is troubleshooting a configuration for EIGRP and OSPF mutual redistribution. Why is the OSPF process not receiving all of the redistributed EIGRP routes?ITExamAnswers asked 1 year ago • CCNPv8 ENARSIHow does Cisco implement interarea OSPF summarization?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. Which two conclusions can be derived from the output? (Choose two.)ITExamAnswers asked 4 years ago • CCNP, CCNAA network engineer has manually configured the hello interval to 15 seconds on an interface of a router that is running OSPFv2. By default, how will the dead interval on the interface be affected?ITExamAnswers asked 4 years ago • CCNA 3 v7, CCNPv8 ENARSIIn a mulitarea OSPF internetwork, which route source descriptor is used to denote the best paths within the internetwork that are as a result of processing type 3 and type 4 LSAs?IT Administrator asked 1 year ago • CCNPv8 ENARSIWhich statement is true about ISP?ITExamAnswers asked 1 year ago • CCNP ROUTEWhich packet switching method is the fastest and creates forwarding tables?ITExamAnswers asked 1 year ago • CCNP ROUTEWhich packet switching method examines the first packet in each flow and the forwarding decision is cached in hardware for subsequent packets in the flows?ITExamAnswers asked 1 year ago • CCNP ROUTEWhat happens to packets that do not meet any of the defined match criteria of a route map?ITExamAnswers asked 1 year ago • CCNP ROUTERefer to the exhibit. On the basis of the information presented, which commands would apply the policy to route all the 192.168.1.0 traffic to the Serial 0/0/0 interface?ITExamAnswers asked 1 year ago • CCNP ROUTEWhich three commands may be used to configure a route map? (Choose three.)ITExamAnswers asked 1 year ago • CCNP ROUTEWhich two Cisco IOS IP SLA statements are true when the target device is running the IP SLA responder component? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTE