IT Questions Bank What occurs when no ip classless is implemented on the router?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Which statement correctly describes this network?ITExamAnswers asked 2 years ago • CCNA 2 v4The following entry is displayed in the routing table: R 192.168.8.0/24 [120/2] via 192.168.4.1, 00:00:26, Serial0/0/1 What type of route is this?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Routers East and West are configured using RIPv1. Both routers are sending updates about their directly connected routes. The East router can ping the West router serial interface and West can ping the serial interface of East. However, neither router has dynamically learned routes from the other. What is most likely the problem?ITExamAnswers asked 2 years ago • CCNA 2 v4How are RIP v1 and RIP v2 similar to one another? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. All routers are running RIP version 2. JAX is configured to just advertise the 10.0.0.0/24 network. CHI is configured to advertise the 172.16.0.0/16 network. A network administrator enters the commands shown in the exhibit. What changes will occur in this network?ITExamAnswers asked 2 years ago • CCNA 2 v4A network administrator installed four new routers that are running RIPv2. Router1 is a boundary router in the RIPv2 network and has a default route configured. Once the network has converged, the network administrator enters Router1(config-router)# default-information originate on Router1. How will this affect the network?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Which command on which router will allow Router1 to learn about the 192.168.0.0/20 network?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Which command will allow Router2 to learn about the 192.168.16.0/28 network?ITExamAnswers asked 2 years ago • CCNA 2 v4A network administrator has been told that the company IP address infrastructure must adhere to RFC 1918. What three IP address ranges from RFC 1918 could the administrator use on the network? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The exhibited network contains a mixture of Cisco and non-Cisco routers. The command debug ip rip was entered on the JAX router. All routers are running the same version of RIP. Router CHI and Router ORL are not able to reach the 192.168.1.16/28 network. What is a possible solution to this problem?ITExamAnswers asked 2 years ago • CCNA 2 v4What is the maximum network diameter permitted by the default metric of RIPv2?ITExamAnswers asked 2 years ago • CCNA 2 v4What are two reasons to implement RIP version 2 rather than RIP version 1? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4What are two functions of the network command used when configuring routing protocols? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4RIPv2 is the configured routing protocol on the routers in a network. The command Router(config-router)# no version 2 is entered on the routers. What effect does entering this command have on routing updates?ITExamAnswers asked 2 years ago • CCNA 2 v4