IT Questions Bank Refer to the exhibit. The network is using the RIPv2 routing protocol. If network 10.0.0.0 goes down, what mechanism will prevent Router1 from advertising false routing information back to Router2?ITExamAnswers asked 11 months ago • CCNA 2 v4A company is using static routes that are configured with an administrative distance of “1” on all routers in the network. The network administrator decides to introduce a dynamic routing protocol to reduce the manual configurations for the static routes. Which option identifies the correct procedure for the dynamic routing to take place in the network?ITExamAnswers asked 11 months ago • CCNA 2 v4The network administrator configures the router with the ip route 172.16.1.0 255.255.255.0 172.16.2.2 command. How will this route appear in the routing table?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v4, CCNA 2 v6, CCNA 2 v7, CCNPRefer to the exhibit. The show cdp neighbors command was run on one of the devices as shown. Based on this information, which two facts can be determined? (Choose two.)ITExamAnswers asked 11 months ago • CCNA 2 v4When the engineer enters the show ip route command on R1, the routing table does not display the static route to the 10.1.1.0 network. All R1 and R2 interfaces are correctly addressed per the graphic. What is a logical next step that the engineer could take in order to make the static route display in the routing table in R1?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. A network administrator accesses router R1 from the console port to configure a newly connected interface. What passwords will the network administrator need to enter to make the connection and the necessary configuration changes?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. When a static IP address is being configured on the host, what address should be used for the default gateway?ITExamAnswers asked 11 months ago • CCNA 2 v4When presented with multiple valid routes to a destination, what criteria does a router use to determine which routes to add to the routing table?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. What is the meaning of the highlighted value 120?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. The router receives a packet that is destined for 192.168.5.79. How will the router handle this packet?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. How many routes are ultimate routes?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A network administrator adds this command to router R1: ip route 192.168.2.0 255.255.255.0 S0/0/0. What is the result of adding this command?ITExamAnswers asked 11 months ago • CCNA 2 v4Which router component contains a scaled-down version of the IOS that can be used to reload a complete version of the IOS in the event that the IOS becomes damaged or corrupted?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. A network engineer has run the show version command on R3. Upon rebooting, R3 does not load the start-up configuration settings. What could be the cause of this problem?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. R1 and R2 are both configured with RIPv1. Beginning from global configuration mode, what comand or commands will eliminate RIP updates on the Ethernet segment of R2?ITExamAnswers asked 2 years ago • CCNA 2 v4