IT Questions Bank Refer to the exhibit. The networks that are connected to R1 have been summarized for R2 as 192.168.136.0/21. Which packet destination address will R2 forward to R1?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. Which combination of network ID and subnet mask can be used to meet the 24 host requirement of the LAN that is attached to Router3?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. Which route in the routing table of R1 will be discarded by its neighboring router?ITExamAnswers asked 11 months ago • CCNA 2 v4What can be determined from the output shown in the exhibit? (Choose two.)ITExamAnswers asked 11 months ago • CCNA 2 v4An administrator is configuring Router1 so that it can connect to Router2 by using IP. Which protocol can be used by Router1 to determine the IP address of Router2 when they are directly connected and only Layer 2 connectivity exists between them?ITExamAnswers asked 11 months ago • CCNA 2 v4Which two statements are true for OSPF Hello packets? (Choose two.)ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. RIPv1 has been used as a routing protocol on the network. A new 172.16.2.0/24 network has been added on router R2 and configured under the RIP routing process. When will R1 converge?ITExamAnswers asked 11 months ago • CCNA 2 v4Which routing protocol by default uses bandwidth and delay to calculate the metric of a route?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. Which two routes are level 1 ultimate routes? (Choose two.)ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. Router R1 receives a packet for destination 192.168.1.10. Which route will be preferred for this packet?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. The IP addresses on all interfaces on router R1 were configured before the OSPF protocol had been enabled on the router. No OSPF router ID was manually configured. Which IP address will be selected by the router as an OSPF router ID?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. OSPF is used for the routing protocol and all interfaces are configured with the correct IP addresses and subnet masks. During testing, it is found that router R1 is unable to form an adjacency with R2. What is the cause of this problem?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. When the show cdp neighbors command is issued from router C, which devices will be displayed in the output?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. The network is using the RIPv2 routing protocol. If network 10.0.0.0 goes down, what mechanism will prevent Router1 from advertising false routing information back to Router2?ITExamAnswers asked 11 months ago • CCNA 2 v4A company is using static routes that are configured with an administrative distance of “1” on all routers in the network. The network administrator decides to introduce a dynamic routing protocol to reduce the manual configurations for the static routes. Which option identifies the correct procedure for the dynamic routing to take place in the network?ITExamAnswers asked 11 months ago • CCNA 2 v4