IT Questions Bank Refer to the exhibit. Hosts that are connected to switch SW1 are not able to communicate with hosts in the same VLAN that are connected to switch SW2. What should be done to fix the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Router R1 is properly configured for router on a stick inter-VLAN routing, but PC1 is unable to ping PC2. What needs to be done to resolve the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What is the maximum number of VLANs that can be deleted from the Switch as it is configured?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What would happen if the network administrator moved the network cable of Host A from interface Fa0/1 to Fa0/3 on switch SW1?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. R1 is configured for traditional inter-VLAN routing. R1 can ping computer 3 but cannot ping computer 1. What is a possible cause for this failure?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Each switch is configured to participate in STP for VLANs 1, 10, 20, and 30. Which switch will become the root for VLAN 20?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Which Spanning Tree Protocol version is in effect?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What happens when a frame from a source MAC address different from 00a8.d2e4.ba27 reaches switch port 0/5?ITExamAnswers asked 2 years ago • CCNA 3 v4What will be the effect of the command S1# copy system:running-config172.16.2.155/tokyo-config?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. When troubleshooting a network, it is important to interpret the output of various router commands. On the basis of the exhibit, which three statements are true? (Choose three.)ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. All routers are configured for OSPF area 0. The network administrator requires that R2 always be the DR and maintain adjacency. Which two configurations can achieve this? (Choose two.)ITExamAnswers asked 1 year ago • CCNA 2 v4, CCNP ROUTERefer to the exhibit. What will happen if interface Serial0/0/1 goes down on Router1?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. All routers are configured with RIPv2 active on all interfaces. Automatic summarization is in effect. Why does the routing table on R3 include the 209.165.200.228/30 network but not the 172.30.1.0/24 and 172.30.2.0/24 networks?ITExamAnswers asked 11 months ago • CCNA 2 v4Which range of IP addresses will be used by RIPv2, EIGRP, and OSPF routing protocols to send routing advertisements?ITExamAnswers asked 11 months ago • CCNA 2 v4A network administrator has been asked to configure a network using a classful IP addressing scheme. Which statement is true about the IP addressing that will be used?ITExamAnswers asked 11 months ago • CCNA 2 v4