IT Questions Bank Refer to the exhibit. What is the purpose of the configuration commands that are shown?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What will happen when frames with a source address other than 0019.d2e4.d9f7 enters interface Fa0/24?ITExamAnswers asked 2 years ago • CCNA 3 v4What are three benefits of employing a hierarchical network design? (Choose three.)ITExamAnswers asked 4 years ago • CCNP, CCNA 3 v4Refer to the exhibit. The network administrator has just added VLAN 50 to Switch1 and Switch2. Hosts A, B, C, and D are correctly configured with IP addresses in the subnet range for VLAN 50. Host A can communicate with host B, but cannot communicate with host C or host D. What is the cause of this problem?ITExamAnswers asked 11 months ago • CCNA 3 v4Refer to the exhibit. Which three options correctly describe the router configuration that is shown? (Choose three.)ITExamAnswers asked 11 months ago • CCNA 3 v4Refer to the exhibit. All switches are configured with the default bridge priority. Which port will act as a non-designated port if all links are operating at the same bandwidth?ITExamAnswers asked 11 months ago • CCNA 3 v4What two methods can be used to remove MAC address table entries from a switch? (Choose two.)ITExamAnswers asked 11 months ago • CCNA 3 v4Refer to the exhibit. Users complain that they do not have connectivity to the web server that is connected to SW1. What should be done to remedy the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The hosts connected to switch SW1 are not able to communicate with the hosts in the same VLANs connected to switch SW2. What should be done to fix the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Each switch is shown with its MAC address. Which switch will be elected as the spanning-tree root bridge if the switches are configured with their default priority values?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What does “FORWARDING” mean in the command output shown?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Switches S2 and S3 are properly connected using an ethernet cable. A network administrator has configured both switches with VTP, but S3 is unable to propagate VLANs to S2. What could be the reason for this?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Which two statements are true about the operation of the interfaces? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A new host needs to be connected to VLAN 3. Which IP address should be assigned to this new host?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Both switches are interconnected via a trunk link. Host A and host B are on the default VLAN but are not able to exchange traffic. What should be done to fix the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4