IT Questions Bank A technician has been asked to run the Cisco SDM one-step lockdown on the router of a customer. What will be the result of this process?ITExamAnswers asked 1 year ago • CCNA 4 v4Which protocol is implicitly denied at the end of an IPv4 access list?ITExamAnswers asked 1 year ago • CCNA 4 v4A system administrator must provide Internet connectivity for ten hosts in a small remote office. The ISP has assigned two public IP addresses to this remote office. How can the system administrator configure the router to provide Internet access to all ten users at the same time?ITExamAnswers asked 1 year ago • CCNA 4 v4Where will a router operating system image be copied after the copy flash: tftp command is issued?ITExamAnswers asked 1 year ago • CCNA 4 v4A network administrator is analyzing the data from a network performance baseline. Which condition will not be indicated in the baseline data?ITExamAnswers asked 1 year ago • CCNA 4 v4Refer to the exhibit. You are a network administrator who has been tasked with completing the Frame Relay topology that interconnects two remote sites. How should the point-to-point subinterfaces be configured on HQ to complete the topology?ITExamAnswers asked 1 year ago • CCNA 4 v4Which wireless solution can provide mobile users with non line-of-sight broadband Internet access at speeds comparable to DSL or cable?ITExamAnswers asked 1 year ago • CCNA 4 v4Refer to the exhibit. Router1 is not able to communicate with its peer that is connected to this interface. Based on the output as shown, what is the most likely cause?ITExamAnswers asked 1 year ago • CCNA 4 v4Which data link layer encapsulation protocol is used by default for serial connections between two Cisco routers?ITExamAnswers asked 2 years ago • CCNA 4 v4Which device encodes data for transmission across the WAN service provider transmission link?ITExamAnswers asked 1 year ago • CCNA 4 v4What type of ACL can be used to force a user to authenticate to the router before accessing a network?ITExamAnswers asked 1 year ago • CCNA 4 v4A network technician analyzes the network and notices late collisions. The collisions occur accompanied by jabber that originates from the server. What is the likely cause of the problem?ITExamAnswers asked 1 year ago • CCNA 4 v4Assuming that the rest of the configuration is correct and that the link has no physical layer problems, what should the administrator do?ITExamAnswers asked 1 year ago • CCNA 4 v4A network technician accidentally deleted the IOS image from flash and rebooted the router. Which two options can be used to restore the IOS image? (Choose two.)ITExamAnswers asked 1 year ago • CCNA 4 v4Which method is most effective in protecting the routing information that is propagated between routers on the network?ITExamAnswers asked 1 year ago • CCNA 4 v4