IT Questions Bank Refer to the exhibit. Packets destined to which two networks will require the router to perform a recursive lookup? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v4How does route poisoning prevent routing loops?ITExamAnswers asked 2 years ago • CCNA 2 v4What command would the network administrator apply to a router that is running OSPF to advertise the entire range of addresses included in 172.16.0.0/19 in area 0?ITExamAnswers asked 2 years ago • CCNA 2 v4In which situation would an ESD strike potentially cause harm to the PC?ITExamAnswers asked 4 years ago • IT EssentialsAn on-site IT technician is attempting to resolve an issue with application performance on a customer laptop. The technician backs up the customer data and then replaces the memory in the laptop with known good memory. It does not resolve the performance issue. What are the next two actions the technician should take? (Choose two.)IT Administrator asked 4 years ago • IT EssentialsUsers in the sales department want to be able to print from laptops and tablets. Which two wireless technologies should the IT technician look for when researching new printers for the sales department? (Choose two.)IT Administrator asked 4 years ago • IT EssentialsRefer to the exhibit. Which statement is true concerning the routing configuration?ITExamAnswers asked 2 years ago • CCNA 2 v4A network administrator needs to assign the very last usable IP address in the 172.24.64.0/18 network range to the router interface that serves this LAN. Which IP address should the administrator configure on the interface?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The network has three connected routers: R1, R2, and R3. The routes of all three routers are displayed. All routers are operational and pings are not blocked on this network. Which ping will fail?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A network administrator has configured R1 as shown, and all interfaces are functioning correctly. A ping from R1 to 172.16.1.1 fails. What could be the cause of this problem?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. All routers are running RIPv1. The two networks 10.1.1.0/29 and 10.1.1.16/29 are unable to access each other. What can be the cause of this problem?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What information can be determined from the highlighted output?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol. R1 and R2 can ping the directly connected serial interface of their neighbor, but they cannot form an EIGRP neighbor adjacency. What action should be taken to solve this problem?ITExamAnswers asked 4 years ago • CCNA 2 v4, CCNPWhat two routing protocols use a hierarchal network topology? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Which router component is used to store the routing table?ITExamAnswers asked 2 years ago • CCNA 2 v4