IT Questions Bank What is the result of implementing a Frame Relay service with a CIR value of zero?ITExamAnswers asked 7 months ago • CCNA Discovery v4What can be broadcast over the wireless network to help a user connect to the network and use wireless services?ITExamAnswers asked 7 months ago • CCNA Discovery v4What best describes the function of QoS in data networks?ITExamAnswers asked 7 months ago • CCNA Discovery v4After a WIC is installed in a two-slot router, the network engineer issues the show running-config command, but the newly installed interfaces in the WIC cannot be seen in the router output. What is a possible reason why the newly installed interfaces are not shown?ITExamAnswers asked 7 months ago • CCNA Discovery v4While troubleshooting a Frame Relay link, the network administrator executes the show ip interface brief command on both sides of the PVC link. All interfaces show a configured IP address and that the line protocol is up. Further investigation reveals that the IP address of the remote router does not appear in the Frame Relay table. Which step would solve this problem?ITExamAnswers asked 7 months ago • CCNA Discovery v4Which IOS component can be used for classification and protocol discovery of network traffic and applications in use?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. An extended ACL has been created to deny traffic from the 192.168.30.0/24 network to the web server with IP address 209.165.201.30. According to Cisco best practices, where should the ACL be applied?ITExamAnswers asked 7 months ago • CCNA Discovery v4What is a characteristic of voice traffic in a converged network?ITExamAnswers asked 7 months ago • CCNA Discovery v4What is a benefit of using CIDR to summarize multiple classful networks into a single network?ITExamAnswers asked 7 months ago • CCNA Discovery v4Which IOS command can a network designer use to help document the active routing status of an existing network?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. What is the purpose of this configuration?ITExamAnswers asked 11 months ago • CCNA Discovery v4, CCNP ROUTE v6.0A network administrator is determining which network address can be assigned to a new remote site with thirty-one users. The logical topology documentation is referenced and it is concluded that the 172.24.32.0/19 and 172.24.128.0/25 address blocks are available. Which network address could be assigned to the new remote site while wasting the fewest addresses?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. Based on the show cdp neighbors detail command, which interface on Switch1 is connected to Router1?ITExamAnswers asked 7 months ago • CCNA Discovery v4A company has just transitioned from traditional telephony to an IP Telephony solution for their voice requirements. What statement describes a characteristic of the new system?ITExamAnswers asked 7 months ago • CCNA Discovery v4A school district decides to use the 172.30.0.0/16 network for its LAN networks. The network administrator must create an addressing scheme to support 500 users in the admin office, 200 at the high school, 60 at the elementary school and 28 at the district office. Which VLSM addressing scheme will correctly address the network with minimal waste?ITExamAnswers asked 7 months ago • CCNA Discovery v4