10.6.2 Packet Tracer – Establishing a Console Session with PT Terminal Answers
Topology
NOTE TO USER: Print the instructions to the lab before proceeding. This Packet Tracer Activity is a companion for the above named lab. The instructions for completing this lab are found on the curriculum page preceding the page from which you launched this activity. You may want to download and print the instructions before proceeding with this activity.
Addressing Table
This activity does not include an addessing table.
Learning Objectives
- Connect a router and computer using a console cable
- Configure HyperTerminal to establish a console session with a Cisco IOS router
Introduction:
PT Terminal is a simple emulation program for serial communication that can be used to connect to the console port on Cisco IOS devices. A serial interface on a computer is connected to the Cisco device via a console cable. Using PT Terminal is the most basic way to access a router for checking or changing its configuration.
Task 1: Connect a Router and Computer with a Console Cable
Step 1. Set up basic physical connection.
Connect the console (rollover) cable to the console port on the router. Connect the other cable end to the host computer with a DB-9 or DB-25 adapter to the COM 1 port.
Step 2. Power on devices.
If not already powered on, enable power to the computer and router.
Note: this process is the same for a Switch.
Task 2: Configure PT Terminal to Establish a Console Session with a Cisco IOS Router
Step 1: Start PT Terminal application.
From the Windows taskbar, start the PT Terminal program by clicking PC0>Desktop Tab> Terminal
Step 2: Use the following chart for the settings of the Terminal Session.
| Setting | Value |
|---|---|
| Bits per second | 9600 |
| Data bits | 8 |
| Parity | None |
| Stop bits | 1 |
| Flow control | None |
Note: this process is the same for a Switch.
