IT Questions Bank A network administrator is tasked with protecting a server farm by implementing private VLANs (PVLANs). A server is only allowed to communicate with its default gateway and other related servers. Which type of PVLAN should be configured on the switch ports that connect to the servers?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Refer to the exhibit. Switch SW2 was tested in a lab environment and later inserted into the production network. Before the trunk link was connected between SW1 and SW2, the network administrator issued the show vtp status command as displayed in the exhibit. Immediately after the switches were interconnected, all users lost connectivity to the network. What could be a possible reason for the problem?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0What are three characteristics of a VLAN access port? (Choose three.)IT Administrator asked 3 years ago • CCNP, CCNP SWITCH v6.0Refer to the exhibit. Both SW1 and SW2 are configured with the PAgP desirable mode. Which statement is true?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Refer to the exhibit. An administrator configured router R1 with two instances of RIPng. Based on the information in the exhibit, what must the administrator do next in order to exchange routes between both RIPng instances?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Refer to the exhibit. Which statement is true about the command ipv6 ospf cost 20?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Refer to the exhibit. What is indicated by the connected route entry?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Refer to the exhibit. A network administrator wishes to apply a routing policy on router WestR1 that will forward web traffic to the ISP while preserving the normal routing to the district office. However, when the configuration displayed in the exhibit is applied, the web traffic is still flowing to the district office. What configuration change should be made to the WestR1 router?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Refer to the exhibit. The network is using OSPFv3 as the routing protocol. Servers A, B, and C offer the same application services. Which type of IPv6 address would be used so that the router will send the packet to the server with the lowest cost OSPF route?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Which two IPv4 to IPv6 transition techniques manage the interconnection of IPv6 domains? (Choose two.)ITExamAnswers asked 4 years ago • CCNP ROUTE v6.0What is the IPv6 prefix used for 6to4 automatic tunnels?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Refer to the exhibit. Which two statements are true of the NAT-PT configurations on router R1? (Choose two.)ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0After activating IPv6 routing on a Cisco router and programming IPv6 addresses on multiple interfaces, what is the remaining step to activate RIPng?ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNP ROUTE v6.0Which two IPv6-specific extensions are incorporated into MBGP? (Choose two.)ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Refer to the exhibit. Host 1 sends a router solicitation ICMP message that requests auto configuration from router R1. Which destination IPv6 address will be used by R1 to send the ICMP router advertisement message that contains the IPv6 configuration options?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0