IT Questions Bank Which Frame Relay topology is a compromise of costs, reliability, and complexity when the WAN contains one headquarters site, 40 regional sites, and several sites within each regional site?ITExamAnswers asked 2 years ago • CCNA 4 v4What is created between two DTEs in a Frame Relay network?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. What can be determined about the configuration of router R1 from the exhibited output?ITExamAnswers asked 2 years ago • CCNA 4 v4Which statement about Frame Relay subinterfaces is correct?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Frame Relay connectivity has been configured in the network and OSPF is used as the routing protocol. Router R1 can successfully ping the router R2 serial interface. When R1 attempts to ping network 192.168.3.0/24 the ping fails. What additional configuration should be applied on all routers to remedy the problem?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Router R1 has been configured for Frame Relay connectivity to routers R2 and R3. Which set of configuration options for routers R2 and R3 would provide each router connectivity to R1?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Which statement explains why the Frame Relay connection between R1 and R2 is failing?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. What effect does the point-to-point configuration on subinterface S0/0.110 have on the operation of the router?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. What can be determined from the output?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. What can be determined about the Frame Relay switch from the output shown?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Which two outcomes occur from the configuration shown? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4Which two items allow the router to map data link layer addresses to network layer addresses in a Frame Relay network? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Router R1 has been configured for Frame Relay connectivity to routers R2 and R3. What configuration option should be configured on the R2 and R3 serial interfaces in order for all routers to ping each other successfully?ITExamAnswers asked 2 years ago • CCNA 4 v4Which best describes the benefit of using Frame Relay as opposed to a leased line or ISDN service?ITExamAnswers asked 2 years ago • CCNA 4 v4Which three actions might a Frame Relay switch perform when it detects an excessive build-up of frames in its queue? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 4 v4