IT Questions Bank Refer to the exhibit. Security Device Manager (SDM) has been used to configure a required level of security on the router. What would be accomplished when the SDM applies the next step on the security problems that are identified on the router?ITExamAnswers asked 2 years ago • CCNA 4 v4Which two statements define the security risk when DNS services are enabled on the network? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4Which two objectives must a security policy accomplish? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4Intrusion detection occurs at which stage of the Security Wheel?ITExamAnswers asked 2 years ago • CCNA 4 v4What are three characteristics of a good security policy? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. What is the purpose of the “ip ospf message-digest-key 1 md5 cisco” statement in the configuration?ITExamAnswers asked 2 years ago • CCNA 4 v4Users are unable to access a company server. The system logs show that the server is operating slowly because it is receiving a high level of fake requests for service. Which type of attack is occurring?ITExamAnswers asked 2 years ago • CCNA 4 v4Which two statements are true about network attacks? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4Which two statements are true regarding network security? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. You are a network administrator who has been tasked with completing the Frame Relay topology that interconnects two remote sites. Router HQ belongs to both the 172.16.1.0/24 and 172.16.2.0/24 subnets with IP addresses of 172.16.1.3 and 172.16.2.3 respectively. Traffic between R1 and R2 must travel through HQ first. How should the serial interface on HQ be configured to complete the topology?ITExamAnswers asked 2 years ago • CCNA 4 v4What consideration must be taken into account if RIP is used on Frame Relay multiaccess networks?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. What can be known about the configuration of router R1 from the output?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Which two statements are true given the output shown? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4What two methods does Frame Relay technology use to process frames that contain errors? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. A ping is sent to address 192.168.50.10 from the Peanut router. Which DLCI will be used to send the ping?ITExamAnswers asked 2 years ago • CCNA 4 v4