Category: CCNPv8 ENCOR
1. Which transport layer port is used in BGP peering? UDP port 289 TCP port 289 UDP port 179 TCP port 179 2. What is the first BGP message type that is sent after a TCP session is established between BGP peers? hello keepalive notification open update 3. …
25. Which statement describes a difference or similarity between OSPFv2 and OSPFv3? OSPFv2 requires the DR/BDR election to occur on multiaccess networks only, whereas OSPv3 requires DR/BDR elections for all network types. Both OSPFv2 and OSPFv3 use the router configuration network command to advertise networks. Both OSPFv2 and …
13. What are two effects of using multiple OSPF areas? (Choose two.) prevention of a flood of queries reduction in the size of the LSDB reduction in the size of the neighbor table limits on the propagation of type 1 and 2 LSAs decrease in the number of …
1. What are two characteristics of OSPF areas? (Choose two.) Area 0 is called the backbone area. All OSPF networks require the use of multiple areas. OSPF areas create a three-layer hierarchical design. All OSPF areas must be directly connected to Area 0. Single area OSPF networks must …
13. Which table is used by EIGRP to store all routes that are learned from EIGRP neighbors? the routing table the neighbor table the topology table the adjacency table 14. Which multicast address does an EIGRP-enabled router use to send query packets? 224.0.0.10 224.0.0.9 224.0.0.12 224.0.0.5 15. Which …
1. Consider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5 What does the 5 at the end of the command signify? metric exit interface administrative distance maximum number of hops to the 192.168.10.0/24 network 2. What type of static route is created when the next-hop IP address …
15.1.2 Lab – Implement NTP (Answers) Topology Addressing Table Device Interface IPv4 Address R1 G0/0/0 172.16.0.2/30 G0/0/1 10.10.0.1/29 R2 G0/0/0 172.16.0.1/30 G0/0/1 172.16.1.1/30 R3 G0/0/0 172.16.1.2/30 D1 G1/0/5 10.10.0.2/29 D2 G1/0/5 10.10.0.3/29 A1 VLAN 1 10.10.0.4/29 Objectives Part 1: Build the Network, Configure Basic Device Settings and Routing …
49. What protocol or technology manages trunk negotiations between switches? DTP STP EtherChannel VTP 50. Refer to the exhibit. An administrator tried to implement an EtherChannel between two switches by grouping the six physical ports as shown. However, the administrator was not successful. What is the reason for …
37. Assuming that all switches in a network have the default bridge priority for each MST instance, what effect does the command spanning-tree mst 10 root primary have when entered on a single switch? sets the bridge priority on the switch to 24586 for MST instance 10 sets …
26. Which two concepts relate to a switch port that is intended to have only end devices attached and intended never to be used to connect to another switch? (Choose two.) bridge ID adge port extended system ID PortFast PVST+ 27. Which spanning-tree enhancement prevents the spanning-tree topology …