IT Questions Bank What are two characteristics of link-state protocols compared to distance vector protocols? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v5Which classless routing protocol supports VLSM and CIDR, supports manual route summarization, and uses the multicast address 224.0.0.9?ITExamAnswers asked 9 months ago • CCNA 2 v5Which factor directly affects the time to convergence?ITExamAnswers asked 9 months ago • CCNA 2 v5Which is avalid summary route for networks 192.168.8.0/22, 192.168.12.0/22, and 192.168.16.0/22?ITExamAnswers asked 9 months ago • CCNA 2 v5What command, or set of commands, would be used to determine if the following configuration on router HQ works as designed?ITExamAnswers asked 2 years ago • CCNA, CCNA 2 v5Which two conditions must exist in order to summarize IPv6 routes into a single static IPv6 route? (Choose two.)ITExamAnswers asked 9 months ago • CCNA 2 v5Which subnet mask would be used for a network that has a maximum of 300 devices?ITExamAnswers asked 9 months ago • CCNA 2 v5Why would a summarized static route be configured on a router?ITExamAnswers asked 9 months ago • CCNA 2 v5What type of static route is created when the next-hop IP address and exit interface are specified?ITExamAnswers asked 4 years ago • CCNP, CCNA, CCNA 2 v5A network administrator enters the following command into Router1: ip route 192.168.0.0 255.255.255.0 S0/1/0. Router1 then receives a packet that is destined for 192.168.0.22/24. After finding the recently configured static route in the routing table, what does Router1 do next to process the packet?ITExamAnswers asked 2 years ago • CCNA 2 v4, CCNA 2 v5Which option shows a correctly configured IPv4 default static route?ITExamAnswers asked 4 years ago • CCNA 2 v5Which of the following are three characteristics of a static route? (Choose three.)ITExamAnswers asked 9 months ago • CCNA 2 v5A router-on-a-stick configuration will not allow PC1 on VLAN 10 to communicate with PC2 on VLAN 11. Which two of the following could be the problem? (Choose two.)ITExamAnswers asked 9 months ago • CCNA 2 v5What command would be used to determine if all SVIs were “up and up” on a multilayer switch?ITExamAnswers asked 9 months ago • CCNA 2 v5How many physical interfaces are required to perform inter-VLAN routing with each method indicated?ITExamAnswers asked 9 months ago • CCNA 2 v5