IT Questions Bank A network technician is configuring a router to support inter-VLAN routing. After entering interface G0/0 configuration mode, the network administrator attempts to enter the command encapsulation dot1q 10. The router refuses to accept this command. What could account for this failure?ITExamAnswers asked 9 months ago • CCNA 2 v5Which three options are valid inter-VLAN routing methods? (Choose three.)ITExamAnswers asked 9 months ago • CCNA 2 v5What are three advantages of having a single trunk link on a switch and subinterfaces on the router instead of individual VLAN links between a switch that has three VLANs and a router to route between the VLANs? (Choose three.)ITExamAnswers asked 9 months ago • CCNA 2 v5Classify each item as either router-on-a-stick, Layer 3 switch routing, or both.ITExamAnswers asked 9 months ago • CCNA 2 v5Classify each item as either physical interface or subinterface.ITExamAnswers asked 9 months ago • CCNA 2 v5The output of the show ip route command contains the following entry: S 10.2.0.0 [1/0] via 172.16.2.2. What value is indicated by the 1 in the [1/0] portion of the output?ITExamAnswers asked 2 years ago • CCNA, CCNA 2 v5What code is used in the routing table to identify routes learned through EIGRP?ITExamAnswers asked 9 months ago • CCNA 2 v5Refer to the exhibit. What is the purpose of the router port that is shown?ITExamAnswers asked 9 months ago • CCNA 2 v5What is a Gateway of Last Resort?ITExamAnswers asked 9 months ago • CCNA 2 v5Which two statements describe characteristics of load balancing? (Choose two.)ITExamAnswers asked 4 years ago • CCNP, CCNA 2 v4, CCNA 2 v5When a router learns that multiple paths are available to a destination network from the same routing protocol, which factor is considered by a router to choose the best path to forward a packet?ITExamAnswers asked 2 years ago • CCNA, CCNA 2 v5During the process of encapsulation, how does the PC determine if the packet is destined for a host on a remote network?ITExamAnswers asked 9 months ago • CCNA 2 v5What address and prefix length is used when configuring an IPv6 default static route?IT Administrator asked 4 years ago • CCNA, CCNA 2 v5Which three statements describe features of Cisco devices that perform routing? (Choose three.)ITExamAnswers asked 9 months ago • CCNA 2 v5Which two design considerations are best practices for switch VLAN design? (Choose two.)ITExamAnswers asked 9 months ago • CCNA 2 v5