IT Questions Bank Refer to the exhibit. A NetworkingCompany engineer is characterizing an existing network for a new customer. The engineer issues a show run command on the branch router to gather configuration information. What is the engineer able to determine as a result of viewing the output of this command?ITExamAnswers asked 7 months ago • CCNA Discovery v4A new WIC is installed in an available router slot. At what point during the router startup process does the router test the card for hardware problems?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. A customer has a problem with connectivity in the network. Based on the IP addressing scheme, what is causing the problem?ITExamAnswers asked 7 months ago • CCNA Discovery v4What are two advantages of using a simulation tool to test an IP addressing scheme? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. The network administrator is configuring the port security feature on switch SWC. The administrator issued the command show port-security interface fa 0/2 to verify the configuration. What can be concluded from the output that is shown? (Choose three.)ITExamAnswers asked 4 years ago • CCNA, CCNA Security, CCNA Security v1.2A high school uses a fractional T1 for Internet access. Wireless network access is provided in approximately 30 percent of the physical campus. Tests performed recently by the IT administrators indicate that the T1 circuit is operating at full capacity. The school district IT design team is asked to propose a network upgrade plan to address two business goals: What can be concluded about the proposal that is presented by the design team?ITExamAnswers asked 7 months ago • CCNA Discovery v4The main office of a NetworkingCompany customer currently connects to three branch offices via three separate point-to-point T1 circuits. The customer network uses RIPv2 as the routing protocol within both the LAN and the WAN. The account manager proposes a change to a Frame Relay network because the costs are lower. A single local loop connection can be installed at the main office with three separate PVCs to connect the branch offices. How can the main office edge router be configured to enable the customer to continue to use RIP as the WAN routing protocol?ITExamAnswers asked 7 months ago • CCNA Discovery v4The customer of a networking company requires VPN connectivity for workers who must travel frequently. To support the VPN server, the customer router must be upgraded to a new Cisco IOS software version with the Advanced IP Services feature set. What should the field engineer do before copying the new IOS to the router?ITExamAnswers asked 4 years ago • CCNA Discovery v4A router has been removed from the network for maintenance. A new Cisco IOS software image has been successfully downloaded to a server and copied into the flash of the router. What should be done before placing the router back into service?ITExamAnswers asked 4 years ago • CCNA, CCNA Discovery v4What is the main purpose of the Access Layer in a hierarchically designed network?ITExamAnswers asked 7 months ago • CCNA Discovery v4A NetworkingCompany engineer is on a support call resolving technical problems for a client network. After the issue is resolved, the engineer also provides a training session for the client’s network support staff. Which position on the networking company team is this engineer performing?ITExamAnswers asked 7 months ago • CCNA Discovery v4At the distribution layer of a hierarchical network, what are two advantages of using Layer 3 devices instead of Layer 2 switches? (Choose two.)ITExamAnswers asked 4 years ago • CCNP, CCNA Discovery v4A network administrator is troubleshooting connectivity problems on a small IPv6 network that consists of two network segments that are connected by a single router. The administrator can ping the IP addresses of local hosts on each segment from the router. Hosts on one network segment cannot successfully ping the IP addresses of hosts on the other network segment. What is the most likely cause of the connectivity problem between the segments?ITExamAnswers asked 7 months ago • CCNA Discovery v4A local car dealership recently purchased an automobile financing company. The owner of the dealership issues a contract to NetworkingCompany to integrate the finance company network into the car dealership network. A router in the existing finance company network requires a password for both Telnet and console access, but no one remembers the passwords. What can the NetworkingCompany network technician do to obtain or change the passwords and gain access to the router?ITExamAnswers asked 7 months ago • CCNA Discovery v4What makes the Cisco EasyVPN application a useful tool for VPN implementation?ITExamAnswers asked 7 months ago • CCNA Discovery v4