Category: CCNA v7.0
10.8.4 Module Quiz – Network Management Answers 1. What are two reasons for an administrator to issue the copy running-config tftp command on a switch or router? (Choose two.) to force an automatic reload of the device to have a backup of the running configuration file in the …
9.6.2 Module Quiz – QoS Concepts (Answers)
9.6.2 Module Quiz – QoS Concepts Answers 1. What is the term used to indicate a variation of delay? speed mismatch serialization delay jitter latency 2. A network engineer performs a ping test and receives a value that shows the time it takes for a packet to travel …
8.4.2 Module Quiz – VPN and IPsec Concepts (Answers)
8.4.2 Module Quiz – VPN and IPsec Concepts Answers 1. Which two statements describe a remote access VPN? (Choose two.) It connects entire networks to each other. It requires hosts to send TCP/IP traffic through a VPN gateway. It is used to connect individual hosts securely to a …
7.6.3 Module Quiz – WAN Concepts (Answers)
7.6.3 Module Quiz – WAN Concepts Answers 1. A company is expanding its business to other countries. All branch offices must remain connected to corporate headquarters at all times. Which network technology is required to support this scenario? LAN WLAN MAN WAN 2. What is the recommended technology …
6.8.4 Module Quiz – NAT for IPv4 (Answers)
6.8.4 Module Quiz – NAT for IPv4 Answers 1. Which two statements accurately describe an advantage or a disadvantage when deploying NAT for IPv4 in a network? (Choose two.) NAT adds authentication capability to IPv4. NAT introduces problems for some applications that require end-to-end connectivity. NAT provides a …
5.5.4 Module Quiz – ACLs for IPv4 Configuration (Answers)
5.5.4 Module Quiz – ACLs for IPv4 Configuration Answers 1. The computers used by the network administrators for a school are on the 10.7.0.0/27 network. Which two commands are needed at a minimum to apply an ACL that will ensure that only devices that are used by the …
4.5.2 Module Quiz – ACL Concepts (Answers)
4.5.2 Module Quiz – ACL Concepts Answers 1. Which two conditions would cause a router to drop a packet? (Choose two.) The ACL that is affecting the packet does not contain at least one deny ACE. No routing table entry exists for the packet destination, but the packet …
3.11.3 Module Quiz – Network Security Concepts (Answers)
3.11.3 Module Quiz – Network Security Concepts Answers 1. The IT department is reporting that a company web server is receiving an abnormally high number of web page requests from different locations simultaneously. Which type of security attack is occurring? spyware phishing DDoS social engineering adware 2. What …
2.7.5 Module Quiz – Single-Area OSPFv2 Configuration (Answers)
2.7.5 Module Quiz – Single-Area OSPFv2 Configuration Answers 1. Which criterion is preferred by the router to choose a router ID? the IP address of the highest configured loopback interface on the router the IP address of the highest active OSPF-enabled interface the router-id rid command the IP …
1.4.2 Module Quiz – Single-Area OSPFv2 Concepts (Answers)
1.4.2 Module Quiz – Single-Area OSPFv2 Concepts Answers 1. What is a function of OSPF hello packets? to discover neighbors and build adjacencies between them to ensure database synchronization between routers to send specifically requested link-state records to request specific link-state records from neighbor routers 2. Which OPSF …